// ---------------------------------------------------------------------------
// Rover control code, ported from trinket rover @
// http://learn.adafruit.com/trinket-powered-rover/source-code
// for the Victoria Makerspace by Thomas Gray
// ---------------------------------------------------------------------------
#include <NewPing.h>
#include <Servo.h>
#define TRIGGER_PIN 12 // Arduino pin tied to trigger pin on the ultrasonic sensor.
#define ECHO_PIN 11 // Arduino pin tied to echo pin on the ultrasonic sensor.
#define RIGHT_SERVO 2
#define LEFT_SERVO 3
#define MAX_DISTANCE 200 // Maximum distance we want to ping for (in centimeters). Maximum sensor distance is rated at 400-500cm.
#define OBSTACLE 10
#define SPEED 50 // adjust speed so that this value moves the rover 1 cm
#define AVOID_TIME 1000 // time to run the avoid process, in ms
NewPing sonar(TRIGGER_PIN, ECHO_PIN, MAX_DISTANCE); // NewPing setup of pins and maximum distance.
Servo leftServo;
Servo rightServo;
void setup() {
// To rotate the servo you just write a value to it, 90 is stop, a value lower then 90 is counterclockwise a value bigger then 90 is clockwise.
leftServo.attach(LEFT_SERVO);
rightServo.attach(RIGHT_SERVO);
}
void loop() {
delay(50); // Wait 50ms between pings (about 20 pings/sec). 29ms should be the shortest delay between pings.
unsigned int uS = sonar.ping(); // Send ping, get ping time in microseconds (uS).
unsigned int distance = (uS / US_ROUNDTRIP_CM);
if(distance < 10) {
leftServo.write(SPEED);
rightServo.write(SPEED);
delay(AVOID_TIME);
}
leftServo.write(90+SPEED);
rightServo.write(90-SPEED);
}